AQUAGAUGE Installation and Operating Instructions eae ee Installation Details Data Logger Differential Pressure Sensor Model Lower the pressure sensor through an appropriate opening in the tank above the water level and allow the sensor to sink to the bottom of the tank The data logger and transmitter case does not need to sit on top of the tank however it should be mounted in a position where the antenna is not obstructed Excess cable can be pushed into the tank
Installation and Operating Instructions for Differential Pressure Sensor Water Tank Level Long Range Telemetry System This system uses 900MHz spread spectrum transceiver modules The modules use frequency hopping technology designed to minimize interference Range is 1 km urban and up to 15 km rural Tank Level Pressure Sensor and RF Transmitter Installation e Lower the pressure sensor and cable through an appropriate hole or opening above the water level in the tank and en
Installation and Operating Instructions for Differential Pressure Sensor Water Tank Level Medium Range TECHNOLOGIES Telemetry System ELECTROSENSE This system uses 100mW transceiver modules with frequency hopping technology designed to minimize interference Range is typically 0 5 km urban and up to 5 km rural with a theoretical 24km range Tank Level Pressure Sensor and RF Transmitter Installation e Unscrew the lid on the tank sensor unit and install 4 AA batteries Se
ELECTROSENSE Installation and Operating Instructions for Air Bubbler OGC Differential Pressure Aquagauge Tank Level Telemetry System Liquid depth is measured using a pressure sensor at the top of a column of air extending to the bottom of the storage tank and this air line is periodically purged and refilled by an air pump By these means the pressure sensor and associated electronics are always isolated from the liquid Backpressure is measured at regular intervals and com