_ WY tas KK Tusk Crank Puller Installer Tool Instructions Note Pulling and installing a crank is an advanced procedure It should only be performed by an experienced mechanic with the aid of a model specific service manual Note If the tool only fits one side of the crank being installed refer to the heat freeze method below The Tusk puller installer consists of 1 housing 1 pulling shaft and nut 1 main coupler 1 12mm x 1 25 coupler fo
Tusk Handlebar Grip Heater Kit Attention Refer to your service manual for your machine s specific wiring information Professional installation may be required if you are unfamiliar with the process Note Compatible thumb heater also available from Tusk Instructions l 6 ra e WT Wes KK Instructions Remove grips They can be cut off or insert a screwdriver between the grip and handle bar to loosen the grip while working it off Clean the
OFF ROAD Tusk Clutch Holding Tool Instructions Note Always refer to your service manual for proper instructions for your specific machine and safety information Improper use may damage the tool or engine parts General information The tusk clutch holding tool can be used to hold the inner clutch hub on most motorcycles and ATVs It is only recommended on inner clutch hubs with square style teeth The tool can also be used to hold flywheels