BladeRunner Ether Cut User Manual CandCNC With BladeRunner AIO SERVO Addendums UPDATED 3 15 14 Covers BladeRuner Ether Cut Unit pictured is a Bladerunner 620 4 withe DTHC IV upgrade and C3 Bus 4 port hub CNC and motion control involves equipment that can cause serious injuries CandCNC assumes no liability for ANY damages to any person or property from the proper or improper use of any equipment CandCNC sells or from any advice verbal or written Use the equipment
REPLACING THE BALANCE BAR TO UPPER ROTOR CONNECTOR There is a small connector which connects the upper rotor to the balance bar If this connector becomes lost broken or disconnected a replacement is included with your Interceptor Follow the replacement steps listed 1 The connector is attached by 2 simple ball joints Remove the broken connector by pulling it away from the axle of the main rotors Once removed the 2 ball joints will be exposed 2 Install the new connector