Hasbro Far East B8072RX 2.4 GHz RF TERRASCOUT User Manual manual

Hasbro Far East Ltd. 2.4 GHz RF TERRASCOUT manual

User Manual

Download: Hasbro Far East B8072RX 2.4 GHz RF TERRASCOUT User Manual manual
Mirror Download [FCC.gov]Hasbro Far East B8072RX 2.4 GHz RF TERRASCOUT User Manual manual
Document ID3110790
Application IDOOxKRZ4LWjKrFejeQfoAaw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize76.56kB (957040 bits)
Date Submitted2016-08-24 00:00:00
Date Available2017-02-21 00:00:00
Creation Date2016-08-24 10:01:57
Producing SoftwareAcrobat Distiller 8.3.1 (Windows)
Document Lastmod2016-08-24 10:01:57
Document Titlemanual.pdf
Document CreatorAdobe InDesign CC 2014 (Macintosh)
Document Author: wikoo

CAUTION:
AGES 8+
TO CHARGE & INSTALL BATTERY IN VEHICLE
Do not aim at eyes or face. TO AVOID INJURY:
Use only darts designed for this product.
Do not modify darts or dart blaster.
CAMERA/
MICROPHONE
TO INSTALL BATTERIES IN CONTROLLER
NOTE: Never charge the battery while it is installed in the vehicle.
1x 9.6v Rechargeable NiMh BATTERY INCLUDED
CAUTION:
3. Plug battery
cord into vehicle.
1. Plug one end of charger cord into
battery, and plug other end into wall
outlet.
•  
   
  
charger.
• LED status light will glow steadily
while battery is charging.
•  
    
battery is fully charged.
Hair entanglement may result if child’s hair
comes in contact with moving parts of toy.
Adult supervision is required.
• ON/OFF BUTTON
• STATUS LIGHT
• CHANNEL
SELECTOR
SWITCH
on reverse side of vehicle

into vehicle.
5. Attach battery
cover. Tighten screw
with a Phillips/cross
head screwdriver.
2. When battery is full recharged,
   
and wall outlet.
4x 1.5V AA
ALKALINE BATTERIES REQUIRED
NOT INCLUDED
Use a Phillips/cross head screwdriver (not included).
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and - polarity
markings.
b. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other types
of batteries. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
ON/OFF • CHANNEL SELECTOR
$      %   & 
STATUS LIGHT
'()*(++   -04
'()*(++   4()89(9
-046 %   #
status light blinks for a short interval, and then vehicle
  7
When done playing, press buttons again to switch
7-044()89(9
Status light glows steadily when it receives a signal.
ASSEMBLY
CONTROLLER
LOAD
CAUTION:
•
•
•
•
•
Be sure to fully charge the battery pack before using.
If the battery pack is hot after use, let cool before recharging.
Do not recharge battery pack if signs of leakage or corrosion are visible.
Do not attempt to open or service the battery pack.
Do not dispose of battery pack in fire.
CHARGING PRECAUTIONS:
TERRASCOUT
2.4 GHz
Input: 100-240V AC, 50-60Hz 10W
Output: 12V DC, 500 mA
Please read all instructions before operating this vehicle.
™
• Do not leave battery unattended while charging.
• Charge the battery on a non-flammable surface, away from flammable items.
• Unplug the battery once fully charged. Do not leave the battery connected to
the charger for an extended period of time.
• Disconnect AC wall charger from outlet while not in use.
• Do not charge battery pack that shows signs of leakage or corrosion, or
attempt to open the battery pack.
• The power adaptor should be used with floor or wall receptacles only.
RELOAD
WARNING:
The charger that is supplied with this item (model #SJC1200500CU)
should be examined regularly for potentially hazardous conditions
such as damage to the plug, enclosures, or cords. In the event of
such conditions, the charger should not be used until the damage is
properly repaired. Only use the charger that is supplied with this item.
x18
IMPORTANT: VEHICLE RECHARGEABLE
BATTERY INFORMATION
CAUTION:
Risk of fire, explosion, and burns. Do not disassemble, crush, heat
above 60 degrees C (140° F) or incinerate. Dispose of the whole
product according to local recycling or waste regulations – never
disassemble. Do not use the item near a heat source such as a fire
or heater.
CLICK
 !"      

   # 
forward to lock it in place.
Load darts into clip.
   
'  % 
CONTROLLER
MOVEMENT
RECORD
LCD SCREEN
LCD SCREEN
RECORDING ICONS
BATTERY
ICON
SUN VISOR
)>4  
if an SD card is inserted.
STATUS
LIGHT
FULL
FUNCTION
ACCESS DOOR
;$  
in blaster. (SD card not
included.)
INIDICATOR LIGHTS
!))@
Steady green light
Vehicle is on
Steady red light
Low power
@
  
 BC
FORWARD/
REVERSE
STICK
BARREL
ELEVATION
ICON
LEFT/RIGHT
STICK
TIMER
CHANNEL
SELECTOR
SWITCH
 H>
• 9%  "H
• (%H
4 
SD CARD
ICON
Vehicle searching for
controller to pair with
BLASTER/CAMERA ELEVATION
Vehicle and controller
connection is broken
Vehicle battery is low.
9  %  
Vehicle is working erratically.
Vehicle battery is low.
9  %  
4  
-      
Static discharge interference.
$  %  7    "
9
  
 BC
No light

4  7
•
•
4  
•
Targeting sight
4   
to pair with
Move toggle switch on controller to raise and
  
'  
 ;?& " 
SAFETY PRECAUTIONS
Low power
Blaster elevation
NOTE: For best
#
store darts in clip.
    
Make sure vehicle and controller are on
 & 
!))@
3. Press record button again to stop recording.
ELEVATION
SWITCH
4 
-    
&  
Steady red light
$  #   #
inserted properly
FIRING
TRIGGER
Make sure darts are loaded correctly into clip,
and clip is correctly attached to blaster.
4   
4()89(9
'%$
 ;
$(I8()
 H
Blinking red light
STORAGE
' 
4I$
Access door is open.
Vehicle does not respond to controller.
-   7
NOTE: Blaster will not function unless access door
is fully closed.
FIRE
Blaster will not fire.
Blinking green light
2. Press record button on the controller to
start recording.
ON/OFF
BUTTON
SYMPTOM

No light
CROSSHAIR
RECORD
BUTTON
TROUBLESHOOTING
-04
40[email protected]9@08
!))@
+  C
4  
connected
Steady light
4      
Flashing light
Battery is fully charged
•
•
•
•
•
Please read all instructions before operating the vehicle.
Operate your vehicle only in wide-open areas. Avoid
collisions with hard surfaces.
Do not operate the vehicle on the street or near fullsized vehicles.
Do not operate this vehicle at night, or on a street or
"      %K
 " %       
Q #  #    %  
while the vehicle is powered on.
      %)%
  %     
Q       6 %  
Distractions can lead to accidents.
)(8>R     %  
and accessories. Do not operate in wet conditions or drive
through puddles.
)(8>8 ) !          
 U   U7    %  
%   C %     
 %       # 7  
  %  #%    
 %  # ;XU;Z  9 
  
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
Hey NERF Nation! Join us online and keep up
with the latest and greatest NERF news! Ask a
parent before going online.
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Product and colors may vary. Retain this information for future reference. YouTube and the YouTube logo are trademarks of
Google Inc. Š 2016 Hasbro, Pawtucket, RI 02861-1059 USA. All Rights Reserved. TM & denote U.S. Trademarks.
B8072 PN 7607280000
ÂŽ

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c321 44.398116, Tue Aug 04 2009 14:24:39
Create Date                     : 2016:08:24 10:01:57+08:00
Metadata Date                   : 2016:06:09 09:26:06-04:00
Modify Date                     : 2016:08:24 10:01:57+08:00
Creator Tool                    : Adobe InDesign CC 2014 (Macintosh)
Instance ID                     : uuid:ea89a53a-6cb5-426d-b878-6345ce29c985
Original Document ID            : xmp.did:FD8259310D206811822AE6D83BF5F58F
Document ID                     : xmp.id:2db9b82a-131a-4661-8e3b-d45dbdad749d
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:c00d6728-929b-4514-ac58-0126ae11a62f
Derived From Document ID        : xmp.did:8079567a-796a-4683-8019-d8b9da5a1199
Derived From Original Document ID: xmp.did:FD8259310D206811822AE6D83BF5F58F
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2014 (Macintosh)
History Changed                 : /
History When                    : 2016:06:09 09:25:54-04:00
Format                          : application/pdf
Title                           : manual.pdf
Creator                         : wikoo
Producer                        : Acrobat Distiller 8.3.1 (Windows)
Trapped                         : False
Slug Family                     : Myriad Pro
Slug Version                    : 1.006
Slug Outline File Size          : 0
Slug Kerning Checksum           : 0
Slug Foundry                    : Adobe Systems
Slug Font Kind                  : OpenType - PS
Slug Checksum                   : 2771909978
Slug Post Script Name           : MyriadPro-Bold
Slug Font Sense 12 Checksum     : 2771909978
Page Count                      : 2
Author                          : wikoo
EXIF Metadata provided by EXIF.tools
FCC ID Filing: RS4-B8072RX

Navigation menu