Operation of Your Opener
Activate the opener with any of the following:
•The Remote Control: Hold push button down until
the door starts to move.
•The Door Control: Hold push button down until the
door starts to move.
•The Outdoor Key Switch or Keyless Entry:
When the opener is activated with the safety
reversing sensor installed and correctly aligned:
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle,
and the opener lights will blink for 5 seconds, when
the invisible beam is broken. If fully open, the door
will not close when the beam is broken. The sensor
has no effect in the opening cycle.
If the sensor is not installed, or is not aligned correctly,
the door won't close from any remote transmitter. You
can close the door with the Door Control, the Outdoor
Key Switch, or Keyless Entry, however, if you activate
them unti/down trave/is complete. If you release them
too soon, the door will reverse.
The Opener Lights will turn on under the following
conditions: When the opener is initially plugged in; when
the power is interrupted; when the opener is activated.
They will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Premium Control Console is activated. Bulb size is 75
SECURITY+ models: Lights will also turn on when
someone walks through the open garage door. With a
Premium Control Console, this feature may be turned
off as follows: With the opener lights off, press and
hold the light button for 10 seconds, until the light goes
on and off again. To restore this feature, start with the
opener lights on, then press and hold the light button
for 10 seconds.
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious injury, death or property
damage. If possible, use the emergency
release rope and handle only when the door is
Trolley I ..°"
To open the door
manually: The door
should be fully closed if
possible. Pull down on
the emergency release
handle (so that the
trolley release arm
snaps into a vertical
position) and liftthe door
manually. The lockout
feature prevents the
trolley from reconnecting
automatically, and the
door can be raised and
lowered manually as
To re-engage the
trolley: Pull the
handle toward the
opener at a 45" degree
angle so that the trolley
release arm is
horizontal. The trolley
will reconnect on the
next UP or DOWN
manually or by pressing
the Door Control push
button or the remote.
Operation of the Door Controls
(SECURITY+ models: See additional programming features, next page.)
Press the lighted push button to open or close the door.
Press again to reverse the door during the closing
cycle or to stop the door while it's opening.
Light Feature -Press the large round Light button. If
the opener lights are off, they will turn on. If the
opener lights are on, (even in the 4-1/2 minute
automatic cycle) they will turn off.
But if you use the Light button to turn the lights on
and then activate the opener, the lights will turn off
after 4-1/2 minutes.
The Light button will not control the opener lights
when the door is in motion.
Premium Console (cont.):
Lock Feature -The Lock feature is designed to
prevent operation of the door from remote controls.
However, the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
To Activate: Press and hold the small round Lock
button for 2 seconds. The push button light will flash
as long as the Lock feature is on.
To turn off: Press and hold the Lock button again for
2seconds.The push button light will stop flashing.
The Lock feature will also turn off whenever the
"SRT" button on the opener panel is activated.